How to Install Easy Crown Molding

627
383

Using a small putty knife, push more compound into and over butt joints. Don't remove too easy crown compound—if you do, the seams will "hollow" as it dries. Cleanup will be easier if you clear away excess joint compound while it's still wet.

DIY Gold Spike Crown using Skewers, Easy

Plaster-coated Foam Molding Get 10 percent more than you think you'll need, to accommodate offcut. Install it starting at an inside corner and work toward any outside corners. In this how-to video, This Old House general contractor Tom Silva shares some tricks of the trade for cutting crown

The materials are lightweight and the installation method very forgiving. Photo by Kolin Smith. Install it starting at an inside corner and work toward any outside corners. Push the two mitered ends together to create the inside corners, making sure their faces align in the corner. Trimroc molding from Canamould Extrusions is a lightweight polystyrene foam coated in hard plaster. Spread mud liberally on each cut end. Once dry, the excess can be sanded smooth. After the joint compound dries completely, sand down the excess using grit sandpaper. If you're working with walls that are out of level and plumb, allow your eye, rather than a level, to guide the position of the molding.

As the compound sets, support long runs of molding with 8d nails. How to Install Wood Crown Molding. The materials are lightweight and the installation method very forgiving. Get the easy crown news, updates and offers from This Old House to your inbox. This Old House has partnered with HomeAdvisor to connect you with trusted home improvement pros! Illustration by Gregory Nemec. Draw a pencil line to mark this positioning so that you can install the crown at this easy crown. A 1-gallon container will cover about 60 feet of molding. Joint Compound Lightweight, easy-sanding premixed compound is best.

To cut the molding at an angle for an inside or outside corner, place it in a miter box upside down and braced against the bottom and side of the box, as if it were angled against a ceiling and wall. Using a handsaw, cut the molding at a degree angle. So in just a weekend, you can upgrade a plain room to an elegant space—and still leave plenty of time for the rest of your list.

Draw a pencil line to mark this positioning so that you can install the crown at this alignment. It cuts smoothly with a handsaw, and, as This Old House senior technical editor Mark Powers shows here, it goes up in a flash with joint compound. Using a small putty knife, push more compound into and over butt joints. TOH technical editor Mark Powers demonstrates how to put up lightweight plaster-covered foam molding.

Billie Eilish - "you should see me in a crown" 100% EASY PIANO TUTORIAL

Hold a strip of molding in place above a door or window easy crown. It cuts smoothly with a handsaw, and, as This Old House senior technical editor Mark Powers shows here, it goes up in a flash with joint compound. Easy crown dry, the excess can be sanded smooth. This Old House general contractor Tom Silva shares his secrets for producing tight-fitting mitered corner joints on

LEAVE A REPLY

Please enter your comment!
Please enter your name here